Download the "Sentinel Protection Installer" application on the keyserver machine.To do this, follow the instructions below. Ansys versions of OpticStudio are not supported with this key type.Īfter you have read the above information, you may begin configuring the software on the key server machine. Client machines must install the Zemax version of OpticStudio.(They may be replaced once installation is complete). Also, if you have other Safenet / Gemalto keys for any other software installed, we recommend you temporarily remove these keys during the installation. Do not plug in your USB license until after the software install is complete.Be aware the install process requires administrator rights.These port numbers were chosen because they are not normally used for any other purpose. The USB licenses work via ports 70 for communication by default.The client machines must be able to ping the keyserver in order for license to be found.You may therefore run one OpticStudio user (or two instances of OpticStudio) on the server machine or any one client machine. Multiple OpticStudio users are not supported on any single machine, as the licensing will only assign one license seat per machine.If only used as a key server, 1GB of RAM and 200mb of available storage is all that is required. If you are going to run a copy of OpticStudio on the server as well, you need a 64 bit version of Server 2008 R2 Sp1 or Windows 7 Sp1, 8.1 or 10. It can run on any 32-bit or 64-bit Windows XP / Server 2003 or later operating system. The server you are installing on needs to be available to the client machines whenever they launch Opticstudio.If you are configuring a server with a Red USB key or softkey network license (key serial numbers are formatted like L100000 or T100000), refer to the following article: " How to configure the keyserver and clients for Zemax network licenses."īefore you get started configuring your keyserver, note the following: Ansys software does not support USB keys. If you are using an Ansys-licensed version of Opticstudio (2022 R2 or newer), see Ansys Zemax licensing overview and guides. Black USB license are a physical USB key and typically have the 5 digit license serial number imprinted on them (22000-40999). NOTE: Before continuing this article, you should be certain that your server has a black USB license. If you are trying to reach an existing license server with a black USB license (you will have been assigned a license number such as 22000-40999) and not setting up a new server, skip to the Configuring the client machine to find the server section. OpticStudio clients must be told where to 'look' to find the key server by entering the server name into an XML configuration file. It must be on the same network where client machines can reach it to use the Zemax license. The Black USB network key is installed on a machine called the keyserver. You must have a working internal network but internet access is not required. This article is intended to help those with a Black USB network licenses install the key server software as well as configure Opticstudio client machines to locate the license.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |